NP205 Rear Output Retainer VSS Kit
NP205 Rear Output Retainer VSS Kit
NP205 Rear Output Retainer VSS Kit
NP205 Rear Output Retainer VSS Kit
NP205 Rear Output Retainer VSS Kit

NP205 Rear Output Retainer VSS Kit

Regular price $158.00 Sale

NP205 VSS Conversion Kit
No more machining stock housings and paying core charges!
This new kit puts the tone ring and sensor on the yoke and in the 5 bolt retainer of the rear output. Simple, bolt-on solution for VSS signal from your NP205.
Also allows you to retain function of your mechanical speedometer cable.
Works with Ford, GM, Dodge with bolt on rear output yoke. Works with 32 spline or our 35 spline "Juggernaut" shafts. Standard size is for 2.125" yoke seal diameter. 
Does not work with slip yoke.

$128.00 shipped in USA
Kit includes: 
40 PPR tone ring
Billet retainer tapped for either standard or metric sensor
Bolts

Also available separately:
Seal and paper gasket $13
Good used 2 wire sensor $25

 

Instructions:

1. Thread sensor in all the way. Be sure it has the oring on it for sealing. 

2. Install yoke seal until it just contacts the sensor. Do not install it too far, or it may damage sensor. 

3. Grease the inside of the yoke seal, then push the yoke through the seal. 

4. Install the tone ring onto the yoke. Make sure the tone ring is just below flush, so that it cannot contact the bearing. Tighten set screw in tone ring.